Hi!
I enjoy MyInfo very much. There is one thing I noticed, and I would like to know if it's me or a bug:
I chose a zoom of "125%" in the toolbar so the text shown in the editor pane has a proper size.
After leaving and restarting the software it still shows "125%" in the toolbar but the text is shown in its original (tiny) size (Arial 12 cpi).
When I change the zoom - to 135% for example - and back to 125%, the text is shown properly again.
Help would be very appreciated!
Best regards
Michael
[fixed] bug in editor pane zoom?
-
- Posts: 8
- Joined: Fri Dec 25, 2020 4:21 pm
Hi Michael,
I have had a similar issue. When I setup a reminder, the reminder did not go off on the time that was set. I did a refresh the notebook and the reminder went off as it should. Not sure it is a bug. I did email Petko about it but never heard back. You may want to try and refresh the notebook to see it that helps. Again not sure if this is a bug or the proper behavior of the software.
Scot
I have had a similar issue. When I setup a reminder, the reminder did not go off on the time that was set. I did a refresh the notebook and the reminder went off as it should. Not sure it is a bug. I did email Petko about it but never heard back. You may want to try and refresh the notebook to see it that helps. Again not sure if this is a bug or the proper behavior of the software.
Scot
-
- Posts: 8
- Joined: Fri Dec 25, 2020 4:21 pm
Hi Scot!
Thank you for your post!
Unfortunately, refreshing the notebook doesn't show any effect. I still have to change a different zoom and change back to get the zoom I want.
Best Regards
Michael
Thank you for your post!
Unfortunately, refreshing the notebook doesn't show any effect. I still have to change a different zoom and change back to get the zoom I want.
Best Regards
Michael
I can confirm that I have exactly the same experience whenever I reopen MyInfo.
Bill
I can confirm that problem. It seems to be introduced in some of the recent updates. It will be fixed in the next update.
Fixed in MyInfo 7.0.9 (build 6738).
Use Help > Check for Updates to get the latest build.
Use Help > Check for Updates to get the latest build.
Just installed the latest build, and this extremely annoying bug has at last been banished. Thanks, Petko!
Bill
-
- Posts: 8
- Joined: Fri Dec 25, 2020 4:21 pm
Same here!
Thank you so much for fixing the issue, Petko!
Best regards,
Michael
Thank you so much for fixing the issue, Petko!
Best regards,
Michael